What causes damage to the router
A broken router or in poor condition, it may mean that the Internet speed that reaches you is not good. There may be cuts or it may even be impossible to connect certain devices. Therefore, preventing this from happening is essential to avoid problems.
High temperatures
Something that can damage the router a lot is that it makes a High temperature. This can happen for different reasons. For example, if you have the router in a covered place, where it cannot be well ventilated. Especially in the summer months, when it is hotter, the temperature can get quite high.
It can also get overheated if you keep it near a window with direct sunlight. That will cause it to receive a lot of heat, overheat and can be damaged. You could run into continuous outages and glitches.
moisture and dust
Humidity and dust are factors that also influence the quality of a router. Especially dust is more common to occur. Sometimes we do not pay much attention to the router and we do not clean it frequently. This causes it to accumulate dirt over time and can cause failures.
Regarding humidity, it is something that can affect any electronic equipment. It can happen if you are in a humid area, where you can even receive water spray in summer. Avoid these places.
other electrical appliances
You should also keep in mind that other devices electronics could affect the operation of the router. If you place it near a television, for example, it could generate interference and make the Wi-Fi work worse, but also cause it to overheat excessively and cause malfunctions.
This will cause the useful life to decrease as well. Avoid placing it near appliances. Ideally, it should be in an isolated, elevated place and away from any source of heat and interference.
Bad components
The router components that are damaged could directly affect the appliance. For example, an Ethernet cable that is broken, if you have changed the Wi-Fi antenna and the one you have placed has a problem, etc. Basically any component that you connect and that may have a problem that damages the router.
Always be careful with the components you connect. Make sure the wiring is working fine and in good condition. This will avoid problems that affect the performance of the device. You can give many uses to the router’s USB port, so you can connect other devices.
Poor care in general
Finally, the use you give it will influence whether the router is better or worse care. For example, yanking the Ethernet cables when disconnecting them, putting things on top that can hit them and the like will cause the device to be damaged and its useful life decrease even if it seems not in the short term.
Our advice is that you take the best possible care of the router, since this will allow your Internet connection to be better and you will not have annoying cuts or speed failures.
