What causes damage to PLCs
Any device that we use can be damaged if we misuse it, have a hardware problem or some problem appears. This can also happen in PLC devices. Could stop working. Let’s talk about what could cause these types of problems.
overheating
One of the usual causes for which PLCs could fail is due to overheating. It is something that also happens in routers, for example. if it does excessive heatif it is located in a bad place, it could cause it to have too much temperature and gradually wear out the components.
To avoid this, it is important that they are located in a correct place, away from heat sources, where they do not receive direct sunlight. It is also essential to keep them clean, since dirt and dust can gradually clog the ventilation and that will affect performance and end up deteriorating.
Using bad wiring
It can also affect the wiring type that you use for PLCs. Especially the network cable you use to connect other devices will influence. If it is in poor condition, if for example it has loose connectors, it can end up affecting these devices. It is important to always use cables in good condition.
But in addition, the power plug can also influence. If you are going to connect it to one that is old, that has some kind of problem, that in the long run could affect the PLCs and end up damaging them. It is a factor to take into account.
Use of rulers
It is not a good idea to use power strips to connect the PLCs. It is better to directly plug them into the power. On the one hand, it could affect performance and cause the connection to slow down or cause continuous cuts to appear. They will not work as we would like and we will have more problems than if we connect them to the wall directly.
But in addition, it could also damage PLCs. They could cause interference and faults that cause the useful life of these devices to decrease. Therefore, it is best not to use these devices and always connect them directly to a socket.
Have other devices nearby
Another thing to keep in mind is that other electronic devices could be to blame for damaged PLCs. They could generate interference, overheating, failures when taking the Internet from one place to another and that make the PLCs not work correctly and complications arise.
Once again, the ideal is place the PLCs in a good place, isolated from other devices and thus ensure that they are at full capacity. With this we will increase the useful life and avoid problems that could put the operation of our connection at risk.
In short, these are some points that we must take into account when using PLCs. It is important to prevent deterioration and damage. If you follow the advice we have given, you will be able to increase their useful life and be able to use them at full capacity for longer.
