is the worst for your home WiFi

Most common mistakes

There are several very common mistakes that are made when we are going to use WiFi, and that is that having any of the following errors that we are going to explain to you under control is critical to obtain the best coverage at home, and also the best real speed possible when we We connect to WiFi.

Router Placement

It is one of the most common mistakes that we make and it greatly affects the WiFi coverage at home. In new homes we normally have a PAU (User Access Point) at the entrance of the house, where the fiber optics arrive and where we can connect the router. Place the router in this location is a complete error, for several reasons:

• It is in a place that is not centered on the house (usually).
• It is put inside a box and placed as we could.
• If we place a mirror or a piece of furniture to cover the PAU in the corridor, we will have even worse coverage and real WiFi speed.

The best you can do in these cases is try to pass the fiber through the ducts to the living roomor connect the ONT here and then a neutral router that distributes the Internet connection throughout the house, and that is located in a central location.

If you already have the fiber connection in the living room, this makes things much easier, because you only have to place the router in a central place without obstacles, so do not put it behind the TV, inside a drawer or behind the piece of furniture. It must be visible to spread the WiFi evenly, and never place a book or anything on top of the router if it is designed to be placed horizontally, like the typical router. Movistar HGU router.

wrong channel setup

Today both the 2.4GHz and 5GHz bands are quite crowded, for this reason it is very important that we choose a channel free of interference. Normally, routers incorporate the possibility of selecting a channel automatically, but it is possible that if there is a new network it will not change the channel until we restart it, since it depends on how the firmware is programmed.

The best thing you can do is set a WiFi channel on both frequency bands, and choose one that is the farthest from the closest WiFi network. In this way, we will have the least possible interference. If our channel coincides with a WiFi router that is very far away, we will hardly have any interference because it is too far away.

Buy repeaters when you don’t need them

Before buying Wi-Fi repeaters that clutter the spectrum, check if locating the router correctly and choosing the right Wi-Fi channel is enough to improve your coverage, otherwise keep this in mind:

• Buy WiFi 6 repeaters with simultaneous triple band so as not to saturate the spectrum so much.
• If possible, buy a WiFi Mesh system with simultaneous triple band, it will work much better for you.
• PLC with Wi-Fi is a highly recommended option in certain cases.

Do not buy repeaters to buy, only do it if you really need it because you are connecting from far away.

Enable Legacy Standards Compatibility

WiFi routers provide compatibility with old standards such as 802.11b/g, if the firmware supports it, it would be advisable to remove compatibility with these old standards, we will notice an improvement in the WiFi speed that we will achieve at home.

There are manufacturers such as ASUS routers whose firmware allows you to configure in detail the protocols that they must support, but not all models incorporate this functionality, rather they usually give priority to compatibility over speed.

Connect dozens of devices simultaneously without mesh network

With each WiFi client you connect, the wireless network will slow down. In these cases, the best thing you can do is disconnect the devices that you are not using to leave the others “free”. Another option is to buy a triple band WiFi Mesh system and distribute the connected devices among the different nodes that we have throughout the house.

As you can see, by solving these 5 very common errors, we can have greater coverage at home and better speed.