The objective is that you can connect other devices and have stability, avoid cuts and achieve adequate speed. Even if you have the best repeater out there, you could run into problems if you don’t use it well. avoid failure It is in your hand and you can take into account these recommendations that we are going to give you.
Use your wireless repeater well
It is precisely when placing the device when we tend to make the most mistakes. We do not look closely at the distance with the router or possible interference. This can cause the signal to arrive too weak and we cannot take advantage of it on the mobile, computer, television or any device that we are going to connect.
Network wire
The main advice is to, whenever possible, connect the repeater by network cable. You can use an Ethernet cable to connect this device with the router to better receive the Internet signal. Instead of connecting wirelessly, you are going to do it by cable and you will achieve greater stability and speed.
Of course, it will be necessary for you to carry out an installation. Perhaps your home is already prepared and an Ethernet cable reaches the room where you are going to put the repeater. If not, you will have to make changes and somehow run the cable from one place to another to connect the repeater and create an access point there.
It is important that the network cable is of quality. At least, it should be category 5e to be able to take advantage of it. In this way, it will be compatible with gigabit ethernet and you won’t be limited to 100 symmetric Mbps, as you would be if you were using a Fast Ethernet cable.
Interference free zone
Another recommendation is place the router well. Mainly, you must move it away from possible interference. If you put it near other devices that can generate conflicts, the signal will not go well. This happens, for example, if you put it next to devices that work through Bluetooth. When operating on the 2.4 GHz frequency, you may have problems.
You should also avoid putting it in a place where it receives a bad signal, mainly because it has walls and walls around it. Also, if you are too far from the router, the connection will not go well and you will have problems connecting other devices. Therefore, you have to try that there is not an excessive distance.
As you can see, it is key to use the Wi-Fi repeater well. Only then can you really improve the quality of the connection and you will have greater speed. It is essential that you take certain measures to achieve this and make no mistake when installing. Alternatively, you can set up a Mesh system.
